I have now fitted the rear door catch and aligned the door a bit better. The alignment is tricky, as the door is a good fit within the aperture. At one side, the glass is not in contact with the rubber seal, but this is because the fibre-glass top has been damaged in that area and will need to be repaired.
The other job this week was to remove the thermostat from the engine and test it. Then this was refitted, and the cooling system refilled with antifreeze. As the weather is starting to get colder, this was needed. The engine was run up to temperature, to check the thermostat operation, and get rid of any air in the system. All seems to be OK.
There may not be much to report as the Winter is coming, but I shall try to do as much as possible.